ttxpc

Rubbersealsaustralia.com Richard and Cathy Schnieder, awesome folks. Tell them J Clark sent you.

Early ones like these have 4 screws that hold the centre divider in, later ones have 1 or 2 on one side and none on the other

You can see it's all one-piece

I'll get some better pics when I do the other side

That's part of the frame, the whole thing comes out of the opening 🤘

Not 100% sure what you mean, the frame is just glued onto the opening with butyl, once it's out you need to undo the centre divider and spread the frame to remove the glass pieces, then clean and paint, replace all the parts, I used a kit from...

They are glued in with butyl, easy enough to get out, lever between the pinch weld and the frame, gently working around it, awful awful stuff to clean up however, I stuck it back in with 227 sikaflex

Finally got around to doing one side, do the other tomorrow, had to wait for some decent weather to paint the frames, original seals were weathered away to dust

Gday all, I thought some on here might be interested in seeing a few dyno graphs from my hj61 with a 12ht over the past 6 years of ownership with various mods along the way. It is also interesting to see the difference when comparing the same...

I did a group buy a few months back for cargo sliding windows for our 60 series and they all sold very quickly. There was a few people interested in sets that werent able to get them. I am doing another group buy for 5 sets in total now. The...

Finally got around to swapping the early engine mount to late, so I could run the late vane power steering pump and drop the engine down where it should be, aftermarket Early mounts are too thick, couldn't get the rocker cover off