WTB: shift linkage
- Thread starter Gumby
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
- Thread starter
- #3
Sweet. Guppie just sold his complete set up with the vacuum stuff for $30 in the classifieds.
$30 without the vacuum stuff plus shipping worth digging it out? If not let me know.
$30 without the vacuum stuff plus shipping worth digging it out? If not let me know.
- Thread starter
- #6
I can't tell if everything is all there. Here's the pic from Spector. I'm looking for everything except the parts that mount directly to the transfer case.
I was studying that diagram yesterday trying to figure out what I have. Looks like from about #24 and up in the picture I have. Not sure on the bottom parts. If you want everything I pictured, let me know. That's all I have linkage related.
- Thread starter
- #8
I'm sure 40 won't be the right length, but it would be nice to have the ends to be able to fabricate a new arm. If you're not using the lower parts for anything, I could make something from one of those rods just as easily.
I don't see 69 in your pic either, but I'm assuming it's just the angle of the pic. That part is pretty important.
The stuff over by 45 I don't need at all.
I don't see 69 in your pic either, but I'm assuming it's just the angle of the pic. That part is pretty important.
The stuff over by 45 I don't need at all.
Part 69 is there, attached to the bracket that mounts on the firewall. You can have all the stuff my pic for the $30 plus shipping (should be cheap). Does that sound good? I can get it shipped out tomorrow if need be.
Should you be missing any other linkage parts, I have all of them from my 45 that I'm not using.
- Thread starter
- #12
I think I'm the only guy on the planet switching back to dash shift. I thought about doing an auto column shifter out of a three on the tree shifter, but I think that would be less cool, especially with buckets.