Wanted WTB 1/2 cut 2H or 12HT

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Dec 29, 2008
Threads
11
Messages
32
Location
USA for now... Liberia long term
Location
United States
Well I have an 86 FJ, I am working with a team from Le Tourneau University to help convert this truck to work in Africa. I am trying to help find a diesel engine

Any thoughts on where I can get a

2h or 12ht 1/2 cut 5speed and t-case? It would have to be shipped to E. TX

Any thoughts are a help, I have looked at SOR, but don't know where else
 
Were you located.
How much in your budget.
12HTEngine 5 spd and cablelocks don't go cheap.
2H alot cheaper still pricey to some.
When do you need it by.
I am working on bringing lower mileage (150-225k)61s for parting.
 
Last edited:
You would need the wiring from dash through to engine.
It would take me 6-8weeks on my end then to 1/2 cut and ship 1-2 weeks.
If you don't have anything in a month PM me.
 
Randy (82 Cruiser) has one for short money. We just pulled it out yesterday. Comes with everything including an H41 4 speed.
 
2h

I have a 2h with a 5spd, pto, and cable lockers with 123,000km . This is not a half cut, but a rolling frame . I also have an 88 high roof hj60, which is complete, except for engine and transmission. The above engine and transmission were going to be installed into the high roof. Both trucks are from Japan. There is a little surface rust on the frame, but none on the doors and body. Any combination can be purchased from a completed truck with everything above, to the rolling frame, engine, transmission and pto, without the cable lockers. The high roof has a full floating rear and it has around 116,000km on it. I also have available a 24 volt winch with the step bumper. Price depends on what you want. Both trucks are right hand drive.

Truck is located in Atlanta,Ga

Bill
 
Well I have an 86 FJ, I am working with a team from Le Tourneau University to help convert this truck to work in Africa. I am trying to help find a diesel engine

Any thoughts on where I can get a

2h or 12ht 1/2 cut 5speed and t-case? It would have to be shipped to E. TX

Any thoughts are a help, I have looked at SOR, but don't know where else

PM me if you still are looking for a diesel motor. I have a complete 12HT with all the trimmings up for sale.

-dogboy- '87 FJ60
 
Back
Top Bottom