wiring up an ARB compressor?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Oct 4, 2006
Threads
636
Messages
23,831
Location
Buckley, WA
Anyone have a link to a straight forward write up as to how to wire up an ARB compressor??

Wiring up anything is a pain in the ass for me and I have no clue what i'm doing.

My dual battery system will be just as fun.
 
I wired up a few years ago but they came with destructions from the company. Have you gone on the companies website to see if they have any ?

A few but no luck. Anything electrical I can't do without plain instructions. Not sure why I understand it till I start doing it. :doh:
 
Thanks for the link.

.... still chinese to me at this point though :doh:
 
try this..
CKSA12-ARB-wiring-12-volt-p.webp
 
Got the compressor, the old slee block for air, two ARB's in my axles, an OEM locker switch.

I'm going to be tracing all the wiring still in the parts truck (good luck with that though, that guy had more wiring in there than in my house :rolleyes:) and try to figure it out. The compressor that was in there is gone though so that is the one thing that is going to throw me off.
 
How many wires are out of the back of the Dial do you know ?

Not too sure... its raining outside now and I called it quits..... i'll get back too it tomorrow.
 
And what is the problem with the rain. Just get in the garage .


HEHEHE.

Well the truck isn't running right now.... but even if it did i'd take about 8 inches out of my house if I tried to drive into the garage. :doh:
 
No I had to drive into SC to pick up some furniture and then look after a sick wife. Non productive day.
 
Back
Top Bottom