Transmission Bearing Puller

[TRAIL TAILOR]

My neighbor came over and asked if I had any use for this puller... Even if I didn't... ITS A TOOL, MUST HAVE MORE, RIGHT!!

Paid him 20$ for it.. Came inside to do some research and HOLY COW these things are 150-200$ online... I feel bad, should I go pay him some more money?

Jason

 

[cruisermatt]

But is it long enough to pull an h42/h41 output shaft bearing?

 

[TRAIL TAILOR]

But is it long enough to pull an h42/h41 output shaft bearing?

IDK and IDC... if not, other ways to get it off... weld some threaded rod and make your own puller... I figure for 20$... if it gets one bearing off in my lifetime it was worth the money... Not always about a Toyota...

Here are the specs...

 

[Weber Sarge]

Those are pretty good pullers , just make certain to use a quality lube on the forcing screw each time you use it - rule applies to all pullers . It should generate enough force to pull nearly any bearing it can reach .
Sarge

 

[FJ60Seth]

Nice score.