trailer harness..aargh!
- Thread starter 177mph
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
e9999 said:
got a pic?
RavenTai said:
google is your friend, maybe this will work:
http://search.cartserver.com/search...rds=1997&keywords_2=Toyota+Landcruiser&GO=GO!
uses the 3 bolts on the lower side of the frame. pretty stout.
gives you close to 3" more ground clearance than the other ones above. It does stick back a bit, though, but that might be good if the truck gets rear ended...
I see what you are saying now.
I have a draw tie on my 62, it does not handle salt very well, do nto knwo if any of the others are any better, probably gonna repalce it with same though.
this a the rediculous aftermath of not beign able to change the ball to another size because it will not let go, the lace hitch finally bent before the ball let go and I decided it shoudl not tow with it.
I have a draw tie on my 62, it does not handle salt very well, do nto knwo if any of the others are any better, probably gonna repalce it with same though.
this a the rediculous aftermath of not beign able to change the ball to another size because it will not let go, the lace hitch finally bent before the ball let go and I decided it shoudl not tow with it.
scottm
SILVER Star
A previous thread on this topic, with links to other threads:
https://forum.ih8mud.com/showthread.php?t=51586&highlight=trailer+wire
https://forum.ih8mud.com/showthread.php?t=51586&highlight=trailer+wire
Thanks for all the great info, My harness looks like the picture, near the spare. I verified the pin orientation and wire colors and ordered from etrailer, 30.94 delivered! Too cool.
Thanks!
Thanks!
I also ordered from etrailer.com, but mine is a 7 pin package.94landcruiser said:
Broke the first time I used it. The flapper doesn't fit tight now that the plastic hinge assy broke. Reported to etrailer and they say I can install another one.....at my expense. Guess they don't stand behind their products.
Not planning on spending any more money there! Assured them I would steer others away as well.
You mean the cover over the trailer connector broke? Their response is not cool.
Not the cover but the main housing where the hinge pin for the cover is held. If it were just the cover I could replace it easily.94landcruiser said:
Think I'll try either epoxy or an aluminum strap to hold the hinge in. Don't believe the hinge needs to rotate in the housing, just in the cover, so epoxy may be OK. To replace the whole housing I would have to cut and splice all 7 wires.
Similar issue, different problem.
My harness is there (and ugly, low down aftermarket hitch) but my issue is that the right turn signal and brake light on the trailer do not work. This is consistant on ANY trailer, so I know it be something in the harness or connection to factory wiring.
Any ideas?
My harness is there (and ugly, low down aftermarket hitch) but my issue is that the right turn signal and brake light on the trailer do not work. This is consistant on ANY trailer, so I know it be something in the harness or connection to factory wiring.
Any ideas?
scottm
SILVER Star
The wires on the factory connectors broke on both my '97s, I had to bypass them with splices, see pics in links above.DTAYLOR said:
