Torsion Bar Adjustment Question

[alleycat]

I have a 2000 LC and I installed 31MM spacers in the back and raised front end via torsion bars 1 inch. The left torsion bar still has some room to adjust higher but the right torsion bar maxed out exactly when I hit one inch up. I don't want them any higher than one inch but I wanted to be sure it's OK to run with the right side bar in it's max up position. Is this OK? Thanks

 

[Porter]

If you plan on aligning (probably a good idea)I would just reindex so you have room for adjustment if necessary. Just did this on mine yesterday, and I'll be driving a bit to get the truck settled and tune the final height prior to alignment in a few days. To answer your question, I'm sure maxed out is fine so long as you're ok with it.

 

[jclarke450]

Agree with the above post. You are almost certainly ok

 

[alleycat]

Ok thanks for replies. I am planning on doing alignment this week