Tips on routing wiring between headliner and roof? 1994 FZJ80

[greenthumb79]

I have a couple of Scan Strut roof entries and i'd like to run a pair of 10 ga. wires and my 2-way antenna coax through the roof in these. I am not quite sure on pulling down the headliner in the rear cargo area though. I pulled back some trim in the rear door area, but wasn't able to figure out how to get the headline down even a little. I didn't want to blindly force it. I couldn't find anything in the FSM nor online that was clear on how to pull the headliner down a bit. Everything i've found is either a later model or something do with more forward in the cab. Do I just pull hard? Pop some hidden clips? I'm running the cables in near the rear passenger factory roof rack mount and down into the rear passenger quarter panel. TIA.

 

[voodu3]

you will have to remove the rear side window to get to edge of the headliner. You could use a fish tape to get it the c pillar where it’s glued down.

 

[greenthumb79]

Thanks. Will give that a shot. The headliner seems very firmly attached at the top the rear cargo door. It had me stumped. I was thinking about trying a fish tape down the C pillar.