Parting Out Texas, 1989 FJ62 (1 Viewer)

[Burky]

driver side headlight bezel?

 

[arcteryx]

driver side headlight bezel?

Few options
New OEM 62 Series, New Headlight Door Bezel, Left/Driver Side
New aftermarket 62 Series, New Aftermarket Headlight Bezel Set
used- email me, I have it from this specific truck

 

[deermike]

Interested in a rear stabilizer bar and components, choke cable, and jack set.
Might you have any of these?

Mike

 

[Alex Waddell]

Are you still parting this out?

 

[Alex Waddell]

Wiring harnesses? ECU? Air Flow Sensor? Exhaust Down pipe with the O2 sensors?

 

[deermike]

Are you still parting this out?

No

 

[arcteryx]

No

I'd appreciate if total strangers would not answer for me.

 

[deermike]

I'd appreciate if total strangers would not answer for me.

I thought you were asking me. So sorry

 

[arcteryx]

I thought you were asking me. So sorry

Ah, I see. No worries.

 

[Alex Waddell]

Partially my bad. I should have PM'd everyone instead.

 

[NotTheMamma]

Parting out 1989 FJ62...

PM sent - thanks

arcteryx -
Thanks for your good parts and time!

 

[Mansweater]

Do you have the headlight bezels or the metal trim that goes around back of rear seat? I'm in Dallas.

Thanks!

 

[docjoe]

Do you still have the rear arm rests? 90815

Thanks

 

[arcteryx]

lot of parts left on this

 

[dandelionbob]

hi, are you parting engine- I need a cylinder head to 95946.

 

[mblommel]

I'm looking for a good rust free roof section. I'm looking for the back 8 or 9 inches of the roof just above the rear upper tailgate. Please let me know if you are interested in cutting it out. I'm located in Orlando FL.

Thanks.

 

[arcteryx]

I'm looking for a good rust free roof section. I'm looking for the back 8 or 9 inches of the roof just above the rear upper tailgate. Please let me know if you are interested in cutting it out. I'm located in Orlando FL.

Thanks.

I just have complete roofs.

 

[FJfire]

Looking for a fuel pump bracket. 714-350-5904

 

[arcteryx]

I don't have that currently.

 

[Zjohnsonua]

Any chance you have a knuckle spindle you'd part from the axle, @arcteryx?