Stock Starter Wiring

[Yo_Han]

Howdy all!

Trying to wire up my crusher to fire her up. It's been 2 years since i pulled her apart and the previous owners did some wonderful hack job on the factory harness.... So i can't use to wiring diagram to help. from facing the back of the soleniod of the starter from the front of the engine I got possible connectors 12 0'clock(A)nut, 3 0'clock(B)tab, 6 o'clock(C)nut and 9 o'clock(D)tab

I got the hot from the battery going to A and the pos from coil to B.
Here's my questions:
1. Where does the ignition lead go?
2. Is there a ground I need to run to it, or is it grounded from the block?

Any pictures would help greatly.

Thanks in advance!
Yo Han

 

[Landpimp]

what kinda starter are you working with, the old kind or a gear reduction? prolly non GR

I have ditched all the non GR starters on my drivers

no ground for the starter to frame.

9 oclock is the alt/charge.

3 oclock is the ign

pic of a 78

[quote author=Yo Han link=board=1;threadid=17583;start=msg170148#msg170148 date=1086547078]
Howdy all!

Trying to wire up my crusher to fire her up. It's been 2 years since i pulled her apart and the previous owners did some wonderful hack job on the factory harness.... So i can't use to wiring diagram to help. from facing the back of the soleniod of the starter from the front of the engine I got possible connectors 12 0'clock(A)nut, 3 0'clock(B)tab, 6 o'clock(C)nut and 9 o'clock(D)tab

I got the hot from the battery going to A and the pos from coil to B.
Here's my questions:
1. Where does the ignition lead go?
2. Is there a ground I need to run to it, or is it grounded from the block?

Any pictures would help greatly.

Thanks in advance!
Yo Han
[/quote]

 

[Yo_Han]

Thanx LandPimp... exaclty what I was looking for. It is a non GR starter. Gotta alot of wires missing or was not being used when she was last running, sure I will have some more questions to come. Wanna crank this baby up

Thanks again!
Yo Han