SM420 wanted - KC area ---

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

E

Eddy

Joined
Sep 10, 2003
Threads
15
Messages
132
After the flat and nasty event, I have decided to go with an SM420 in my FJ40.

Looking for complete trans with a chevy bell housing in the KC area.

I am willing to pull from truck and or trade other FJ40 parts....

What kinds of adaptors are people using for the toyota transfer case?
- I see the exteme bends adapter and the Advance Adaptors version.

Thanks

Ed
 
Ed!! Look in the parts for sale section rite here on Mud. There is a feller sellin jus what you are askin fer. Make him an offer. Oh, I think it was down ta Dallas er sumptim. That ain't far....
Purdy much all yud havta do is switch to a chevy clutch disc. an get a sleeve that goes over the input bearin retainer. Might havta open the hole in the floor a bit. Drive shafts may be a issue. Rite now I am runnin a stock lenth rear 4 speed shaft. Looks a liddle short but been in there werkin bout 8 months now. Yer frunt one aud need shortnin. Purdy easy swap all in all. An well werth it too!!!
Get er Dun, Don P.
 
Ed!! Look in the parts for sale section rite here on Mud. There is a feller sellin jus what you are askin fer. Make him an offer. Oh, I think it was down ta Dallas er sumptim. That ain't far....
Purdy much all yud havta do is switch to a chevy clutch disc. an get a sleeve that goes over the input bearin retainer. Might havta open the hole in the floor a bit. Drive shafts may be a issue. Rite now I am runnin a stock lenth rear 4 speed shaft. Looks a liddle short but been in there werkin bout 8 months now. Yer frunt one aud need shortnin. Purdy easy swap all in all. An well werth it too!!!
Get er Dun, Don P.
 
PM ya Trainrech... Thanks for the info everyone. This will be going behind a Chevy Small block - hence the Chevy Bell housing - then to a 3 speed transfer case.
 
Ed,
Check here https://forum.ih8mud.com/showthread.php?t=77211 I've not had many dealing with Jewell but I wouldn't hestitate to buy parts from him.

I can get this hauled back to Wichita the end of the month and haul it to KC in November

Mike
 
Found one from Trainrech... PM you back again.

That was quick - thought I would be looking for awhile.

Now to look for the adaptor to the 3 speed t-case.

Thanks Everyone... Advise is still open.........
 
You must log in or register to reply here.

Similar threads

T
LC100 windshield replacement: KC area
Replies
6
Views
1K
BILT4ME
BILT4ME
CrowleyFJ40
  • Sticky
TAC Want to Buy 2025
Replies
0
Views
576
CrowleyFJ40
CrowleyFJ40

Users who are viewing this thread

Total: 1 (members: 0, guests: 1)

Share this page

Back
Top Bottom