Slee Coil Spacer Question

[alleycat]

After installing a set of 285/75/16 Hancooks, I also installed a pair of Slee 30mm coil spacers in the rear of my 2000 LC. I then cranked up front torsion bars 1". After driving a hundred miles or so I had a front end alignment done. The LC looks great, tracks nicely at all speeds and seems to be performing perfectly.

Question is - after performing this work is there anything else anyone would recommend doing? All seems well but I wanted to be sure that I did not miss any adjustment that should be addressed because of height increase. Thanks

 

[CharlieS]

Are there issues with brake proportioning valve like the 80's have?

 

[REZARF]

Nope, you're done after an alignment. I am about 5,000 miles on my spacer after doing what you described. Just check after its settled that your front has the slightest rake to it, the 100s seem to track better with a about a .25-.5" lower front from the rear.

 

[alleycat]

I'm lower in front than .25 - .5". But would like a little more height. After she settles in, I may take her up a bit but I am a little wary because I have read that some folks don't recommend more than an inch up on the torsion bars. Thanks for the reply. This setup really gave the rig a great look without big $$ investment. Installing spacers was cake!!

 

[wolffo]

get it sweet and go get it aligned again