I don't tend to hang out here, however, recently I installed a Scosche M8rix switch control in my 2nd gen Sequoia. I have never gone with a switch setup like this before. I tend to wire individual switches with fuses and relays. I generally dislike using butt connectors and prefer solder and shrink tube when attaching pigtails, I prefer crimping new terminals on when I can.
On that note, I spoke with Scosche tech support to determine which terminals to purchase and they couldn't get me an answer. I ended up depinning the plugs and measuring them. I knew they were Metripack plugs buy needed the measurements.
The 2 30 Amp plugs are Metripack 480 series with 10awg wire.
The 4 pin 15Amp plug is a Metripack 280 with 14Awg.
The final 8 pin plug for 10Amp circuits is a Metripack 150 running 14awg.
It is a neat little switch control and has a lot of programmable functions. It really makes for a clean, simple, modern looking installation. It is expensive, but I think it could be worth it depending on your needs.
On that note, I spoke with Scosche tech support to determine which terminals to purchase and they couldn't get me an answer. I ended up depinning the plugs and measuring them. I knew they were Metripack plugs buy needed the measurements.
The 2 30 Amp plugs are Metripack 480 series with 10awg wire.
The 4 pin 15Amp plug is a Metripack 280 with 14Awg.
The final 8 pin plug for 10Amp circuits is a Metripack 150 running 14awg.
It is a neat little switch control and has a lot of programmable functions. It really makes for a clean, simple, modern looking installation. It is expensive, but I think it could be worth it depending on your needs.
