- Location
- United States
Right Upper Fender needed
- Thread starter bigsal
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
Should have something available in the coming days, if no one else turns up anything.
https://forum.ih8mud.com/fj55-classifieds-corner/753187-71-parts-potential-listed-500-a.html
https://forum.ih8mud.com/fj55-classifieds-corner/753187-71-parts-potential-listed-500-a.html
- Thread starter
- #3
Thanks! If it's straight and not rusty, that would be an improvement over mine.
Cheers,
Stew
Cheers,
Stew
I may wind up with choices, hard to say.
Have two sets on hand and a third set, in the form of an entire parts Pig, coming.
Let the body man take his pic, first then the rest will be available.
The parts Pig panels actually seem to look better than the other two, but only had moments to look at before I was ran off by dog.
Can't guarantee rustiness.
Gonna carve and depict the pork early to mid week, next week.
Have two sets on hand and a third set, in the form of an entire parts Pig, coming.
Let the body man take his pic, first then the rest will be available.
The parts Pig panels actually seem to look better than the other two, but only had moments to look at before I was ran off by dog.
Can't guarantee rustiness.
Gonna carve and depict the pork early to mid week, next week.
- Thread starter
- #5
Cool. Thanks! Mine have rust holes poking through at the seam with the lower fender. I can deal with surface rust.
Sounds like you're quite the pig stalker. Your posts sound like "Tales from the Pork Chopper..."
Sounds like you're quite the pig stalker. Your posts sound like "Tales from the Pork Chopper..."
I've learned it takes two to three to come up with enough good to build one. Haha.