Hi folks,
My 100 series had it's 2nd windscreen replacement since I've owned it after 1 year and after the 2nd was installed I noticed the top moulding is quite perished and soft, and is no longer sitting against the body firmly and sealing like it should.
Additionally, some rust has reappeared so I'd like to sort it out properly.
I REAAAAAALLLY don't want to have to remove the side mouldings as they have been fitted to be watertight (all the rivet holes were massively oversized and had to have a mixture of sealant and larger rivets).
I think it's possible to remove this top moulding with everything else still in situ, but would welcome anyone's views if they've done this before, before I remove the old one and find it's not possible to fit the new one.
Pics below of the offending piece of moulding, and the flap on the side mouldings which should allow removal/install.
Thanks!
My 100 series had it's 2nd windscreen replacement since I've owned it after 1 year and after the 2nd was installed I noticed the top moulding is quite perished and soft, and is no longer sitting against the body firmly and sealing like it should.
Additionally, some rust has reappeared so I'd like to sort it out properly.
I REAAAAAALLLY don't want to have to remove the side mouldings as they have been fitted to be watertight (all the rivet holes were massively oversized and had to have a mixture of sealant and larger rivets).
I think it's possible to remove this top moulding with everything else still in situ, but would welcome anyone's views if they've done this before, before I remove the old one and find it's not possible to fit the new one.
Pics below of the offending piece of moulding, and the flap on the side mouldings which should allow removal/install.
Thanks!
Last edited:
