Plugs to fit holes where fender flares attached (1 Viewer)

[ChadHahn]

I ripped part of one of my 1997 Toyota Land Cruiser's rear fender flares off. Eventually the part over the rear quarter panel started coming loose so I took it off. I was wondering what size plug I should use to fill the holes in the body where the clips went? I'm thinking there has to be a flush fitting piece that would clip into the hole. It helps that my car is black so it would blend in.

 

[jfz80]

You will Probably need different sizes as the holes are not uniform in size. I used some by Hillman avail at Lowe’s/depot. Had to pick up smaller ones for the bracket that’s riveted to doors once I drilled out the rivets. I added a dab of RTV to the back to keep the few lose ones tight to the body panel.

Builds - A Touch of Gray build

Well another year has gone by and not too many changes. I went back to an OEM driveshaft with original ujoints and 235k miles. Wasnt the plan; the shop was supposed to retube it with 1/4'' tube and then replace the ujoints. The technician didnt replace the joints and when I asked why he...

forum.ih8mud.com

plugs were from lowes home improvement. Hillman #881199 variable depth push fastener GM $.80 per pair

 

[ChadHahn]

Thanks. That's a good start. Those are what I was picturing.

 

[jjdeneen918]

I’d love to see the after photos.

 

[ChadHahn]

I’d love to see the after photos.

I'll be sure to post some pictures.

 

[jfz80]

I’d love to see the after photos.

One from the thread linked above.