Parting 1997 locked LX450

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jul 28, 2007
Threads
143
Messages
838
Hello All,

I picked up a wreck for the engine for my trail rig and will be parting out the rest. The truck is a 1997 Lexus LX450 with 237927Km or 147840 Miles on the clock. My truck is locked so other than the parts I need this truck is all got to go. Here is a partial list and prices. The Truck is located in Sparwood B.C. which is three hours from Calgary and an hour and a half from either Eureka Montana or Cranbrook B.C. It's all got to go so make me an offer. All parts are plus shipping on your dime. I'll ship the cheapest way possible and charge only the shipping cost. If you don't see the part you want PM me and I'll get back to you. I do work full time but will peal off the parts as fast as I can as I want this gone so I can have my truck back on the road for fly fishing and camping season.

I'm keeping the engine, sun visors and power seat control off the drivers seat which is in rough shape. They do have seat warmers ... too bad I'm not ambitious enough to swap over the leather.

SOLD STUFF
Lockers Hub to hub, wiring and switch 1400. I'm not willing to break the set down Sorry. SOLD
Instrument cluster SOLD
Alternator SOLD
Seat belts (front and middle) SOLD
Console and gear shifter trim SOLD
Rear glass from hatch SOLD
Steering wheel SOLD
Drivers side window switch TRIM SOLD
Hitch ... pending
door panels ....pending
cruise control .... pending
Antenna motor GARBAGE
dome lights pending

Some parts are below plus way more available
Front drive shaft 75
Rear drive shaft 75
Master Cylinder 75
Brake booster 50
AC Compressor with clutch 75
Rear wiper assembly 75
DS Rear panel in cargo area, covers toolkit 10
Hitch 50
4 Lexus alloy wheels with very good tread >80% Michelin 275 70 R16 LX M/S on them ....... great winter tires! $500 (not shipping them pick up only)
cruise/wiper switch (right side) 50
starter 50
Air Flow Sensor 40
Transmission cooler shot
Hood Gas Struts 25
Radiator 75
Windshield Wiper Reservoir with motor 15
IMG_9623.webp
IMG_9625.webp
IMG_9626.webp
 
Last edited:
a few more

Many of the body panels, even the ones that look good are in rough shape. I wouldn't sell anyone anything off the passenger side. The truck looks like it was side swiped and someone used a spade to put the bondo on.
IMG_9627.webp
IMG_9629.webp
 
What's that steering wheel like? What about the driver's side rear door ashtray? Maybe some other things I need but I'll have t othink of those. Shipping is to 35244. I'll PM you also.
 
diff lock switch ?

The pix shows a diff lock swtich. Is the transfer a full time or has it been modified to 'part time'. If it is 'part time' mod I would take it as well. Thanks Dan
 
Sorry Dansawyer You got beat to the punch by about 15 minutes! I got an email for the lockers and a pile of other parts. I'll update this evening as to what is gone.

Again Sorry, I know they are hard to come by.

Dave
 
body panels

I've had some interest in many of the body panels. I would not want many of these on my truck. This truck has been painted and there is some awful body work on it. The paint looks like hell, is full of orange peal and had gone flat where the bondo was not sealed properly. Unless your wanting a panel for a wheeler I would stay away. Here is a pic of the lift gate to provide a visual aid ........ some stone handed, blind blacksmith painted this baby. The hood and passenger side front fender are salvageable but I would be stripping and repainting them.
IMG_9630_2.webp
 
Last edited:
What's that steering wheel like? What about the driver's side rear door ashtray? Maybe some other things I need but I'll have t othink of those. Shipping is to 35244. I'll PM you also.

oops, sorry you were first on the wheel ... 25 fair for the wheel?
 
I'm looking for a cruise control actuator, with the cable, mounting bracket and wiring connector/loom back to the first engine bay 7 pin connector.
 
It's there. PM or email me.

Thanks

I'm looking for a cruise control actuator, with the cable, mounting bracket and wiring connector/loom back to the first engine bay 7 pin connector.
 
starter

This was in the back seat. I field tested it just to be sure. New.

60$
IMG_9636.webp
 
Would be interested in the rear taillight housings. I need the driver side, but I think I need both if I want it to match. Can you shoot some pics of the rear to compare? Thanks
 

Users who are viewing this thread

Back
Top Bottom