Needed M100 Lunette (1 Viewer)

[boots]

I am re-installing the Pintle and Lunette setup on my M100 trailer, I have the Lunette casting (came with the trailer) but the Lunette is broken.

I have taken it to a GOOD welder in the area for repair but when he tryed to weld it, it was a no-go. Seems the Lunette has some kind of contamination in the casting and the weld will not work right. The welder said he would rather not do not job because of this.

So in short I need another Lunette. Have found a new one from Midwest for $185 however I am trying to find a good used one. Also open to buying a complete set-up from a M416, Lunette and Casting.....

Thanks Boots

 

[boots]

Ok guy's. Looking into a hitch system called a "Lock N' Roll" anyone have any insite into this set-up ?

 

[cruzzer]

They work great.. If your going to do this I recommend making a receiver that is welded in or bolts in your "a" frame of the trailer and the lock-n-roll will slide into.. also when you want to secure the trailer you can put in something to keep it from being stolen..
Check out REZARF's build page 4-5 or so has some great insite on hitch couplers,, here is a pic from that thread,,

 

[Brian in Oregon]

Or.... you could build a hitch like this....

https://forum.ih8mud.com/trailer-tech/219343-my-other-jeep-trailer-bantam-civilian-model.html

 

[boots]

Thanks Guy's,

Both set-ups are nice. Guess I should have looked around a little better.

I think iam going to go with the Lock N' Roll system. Just need to install a receiver onto my trailer.

Cruzzer, got your PM. Think I will take you up on the offer.....