MOULDING, ROOF DRIP SIDE FINISH installation question?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Apr 2, 2018
Threads
4
Messages
33
Location
Austin, TX
Hi, my rubber ROOF drip mount was missing. I bought the rubber drip/gaskets and was wondering if these just slide in and stay or if I need to glue them down?
Thanks.

B90A7A7B-CBB2-4A5F-909B-AE16174E5A6C.jpeg
 
They just slip in with a friction fit. I had to replace all four of mine this past week when I noticed they were gone. (Truck is new to me.) Partsouq was the cheapest alternative. The new ones seem rather secure, but since all mine were missing, gluing them in place may not be a bad idea.
 
They are regularly ripped/pulled off by automatic car washes. Ive lost 3 that way on mine. Now, I rarely use those car washes but make sure to check after every time I go through. In fact, just last week there was a tacoma in front of me that I watched the washer wheels peel his roof trim right off.
 
What are the part numbers?
7555560020 Genuine Toyota MOULDING, ROOF DRIP SIDE FINISH, CENTER, RH/LH 75555-60020
This item fits to Left Hand side or Right hand side.
OEM bought on eBay.
I’m glueing these down and no more touch/brush car washes
 

Users who are viewing this thread

Back
Top Bottom