Metal-Tech Roll Cage

[grayfj40]

Hi all,

I got a metal-tech full cage for my 74 fj40 and have completed about 80% of the fabing. I was looking for some help with the last 20%. This is what I need help/ advise with:

1) The rear diagonal support bar from the B to C pillar.

2) The A to B pillar tie.

I'm in centeral CT.

Any help would be greatly appreciated.

 

[yodafrick]

Not quite sure exactly what you need help with (bending, welding, etc.) but all my cruisers live in Durham and I'd be glad to help/meet a local cruiserhead. I'll be in Durham Sat & Sun. wrenchin. Swing over or we''ll meet up.

 

[vfrer]

Hey Mud Eater... where did you get your cage? Was it local? Shipped? I've been thinking about getting one. I'm curious what you need help with too... is additional fabbing required with the kit? I was planning on doing the welding but wasn't expecting to to much more than some light trimming to make things fit.