Hi all,
I've just overhauled an M12000 that I picked up used and am getting ready to put it all back together. It will be mounted in the newer model ARB bull bar bumper which I have not purchased yet and I don't have access to one to look at in person. I want to make sure I clock the clutch lever to the right position during assembly so I don't have to pull it apart again later and risk wrecking a gasket. On ARB's web site the assembly instructions show the clutch handle positioned at the top front quadrant. In this position it seems very close to the front inside surface of the bumper and looks like it would be hard to get at. Seems like it would be easier to access at the top? Can someone please confirm that the picture in ARB's instructions is correct and maybe post a picture of their installation so I can get a better feel for it?
Thanks!
I've just overhauled an M12000 that I picked up used and am getting ready to put it all back together. It will be mounted in the newer model ARB bull bar bumper which I have not purchased yet and I don't have access to one to look at in person. I want to make sure I clock the clutch lever to the right position during assembly so I don't have to pull it apart again later and risk wrecking a gasket. On ARB's web site the assembly instructions show the clutch handle positioned at the top front quadrant. In this position it seems very close to the front inside surface of the bumper and looks like it would be hard to get at. Seems like it would be easier to access at the top? Can someone please confirm that the picture in ARB's instructions is correct and maybe post a picture of their installation so I can get a better feel for it?
Thanks!
