Lost Throotle During Stereo Install

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Apr 8, 2013
Threads
8
Messages
36
Location
Leicester
Hi please help...
I was installing after market stereo on my LC100 UZJ100 2003 and after lots of research finally got most wires in place. stereo was working n all. When I was putting stereo back into dash I shorted something (maybe cos forgot to put tape over some wires which had some voltage), and now my constant 12v has gone and car got check engine light and accelerator doesn't work. Error was showing camshaft sensor and throttle but all were fine before I shorted whn installing stereo.

I have a doubt that a relay has blown which is connected to all above. Please help me in finding out which relay if infact it is a relay.

ACC is fine and its fuse also fine (of course :-))

2 more questions...
1. Which wire is illumination on harness .. I assumed Green but apparently its not that... all others I got from various manuals perfectly just not Illumination.
2. Where can I tap reverse light positive from dash part of vehicle don't wanna tap in reverse light from behind as its modded to bottom bumper n cant get to wire easily.... need for reverse camera signal.

Thankx in advance
JK
 
OK I got the issue of throttle I by mistake took out the etcs fuse and put it back but in wrong place.. so that's sorted.. found the radio fuse on right footwell.

Illumination I noticed im not getting any illumination on the dashboard buttons... anyone know what that could be.

Reverse is it possible Red-Black on E8-2... thanks.
 
Back
Top Bottom