Hey guys, I was changing my transmission gasket as its been leaking for awhile and i wanted to get it off the list lol. i reinstalled the pan/dipstick and when i went to add fluid the fuel filter/primer were kinda of in the way so i removed the 2 bolts and pushed it to the side well i added the trans fluid back.
I installed everything and went to start it and it would turn over but never actually start. eventually i got it to chug a little bit but never fully run. i thought maybe by laying the filter on its side air got into the injector lines so i tried to prime it and no luck.
I tried bleeding the injectors,(fuel to the injectors but still not starting). also jumped the scanner and everything came up normal
before this the truck ran perfect.
so im wondering if anyone has any ideas.
maybe a earth around the trans drip stick i could if hit or something.
Hope everyone has a good weekend and stays out of the rain unless ur playing in it
I installed everything and went to start it and it would turn over but never actually start. eventually i got it to chug a little bit but never fully run. i thought maybe by laying the filter on its side air got into the injector lines so i tried to prime it and no luck.
I tried bleeding the injectors,(fuel to the injectors but still not starting). also jumped the scanner and everything came up normal
before this the truck ran perfect.
so im wondering if anyone has any ideas.
maybe a earth around the trans drip stick i could if hit or something.
Hope everyone has a good weekend and stays out of the rain unless ur playing in it
