Help with CDL and Hazards (1 Viewer)

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jun 30, 2025
Threads
1
Messages
2
Location
NC
So I am the proud new owner of a 2000 100 series and am taking care of a few issues. I am having trouble with the CDL and Hazards not working. So I checked the fuses and have replaced the switch on top of the transfer case. Still nothing, so then I pulled the head unit/hvac trim off and took a look. I seem to be missing the cable that runs from the CDL and hazard circuit board to the main board. No wonder they were not working. I can not find one anywhere, but may be able to make one if I had another one to look at. Does anyone have one laying around that they can part with or a picture of the cable?
 
I did contact an electronics repair shop in town. They said that they could hardwire it if we couldn't find the correct connector. This sounds ok as long as the wires on the factory assembly don't cross. Or if they do we know what terminals they go to. So if anyone has a pic of a factory wire or a diagram that would be great. If this doesnt work I will probably try to find the whole assembly from a junker.
 

Users who are viewing this thread

Back
Top Bottom