Help with ahc lean, sensor did not adjust anything, weird negative numbers.

[05ls430518]

Here is the numbers from a snap on scan tool, I adjusted the front drivers side sensor to match the passenger side and it is still sagging. Do these numbers look off to you guys? Any help is appreciated.

 

[shajbot]

Rear springs are different length. Even if AHC is perfect there will still be a lean. Look into replacing one of the rear springs for the other one (L vs R) and you should get pretty close.

 

[05ls430518]

Rear springs are different length. Even if AHC is perfect there will still be a lean. Look into replacing one of the rear springs for the other one (L vs R) and you should get pretty close.

That would level out the front drivers? How can you tell the springs are different length? I appreciate the help thank you very much.

 

[skymast]

is it sagging visually or just in the numbers?

 

[05ls430518]

is it sagging visually or just in the numbers?

It's visually sagging by a quarter of an inch on the driver's side front.

 

[lx200inAR]

If it's only 1/4", my recommendation is to unsee it and go about your life. Most likely no amount of messing with sensors will change anything. If you want to add spacers to attempt to tune the height, that might have some affect. (Including possibly doing something with the rear as that can have an effect on the front).