H55F transmission, bolt pattern where attached to bellhousing (1 Viewer)

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jan 4, 2019
Threads
42
Messages
288
Location
Wilmington, North Carolina
We are looking for an accurate drawing of the bolt pattern at the H55F bellhousing end.
PDF, CAD DWG or DXF, hand sketch, or other format.
Trying to configure an adapter for an Isuzu 4BD1T swap due to a blown 3B.
Suggestions and words of wisdom are appreciated.
 
Which flywheel housing is on it now?
3B.
We are hoping to fabricate an adapter between the Toyota bellhousing attached to the H55F and the Isuzu bellhousing half that is attached to the engine. Just haven’t pulled the 3B yet and was hoping to get ahead of the planning with some drawings.
 
And I mis-stated the original request. It's the engine side of the bellhousing needed. This side:
1665572459900.png


We've got one rough sketch, but something like the old school pencil shading sketch with a few dimensions would help. Like this:
1665572512862.png


1665572167848.png
 

Users who are viewing this thread

Back
Top Bottom