H55f/H41f dimension (1 Viewer)

Joined
May 19, 2005
Messages
273
Location
Northern Kentucky
 
 
 
Done a search with no luck:frown: . Does anybody out here have the dimensions for a H55f? I'm looking for the distance from the end of the input shaft(pilot bgr end) to the face of the transmission(where it meets the bellhousing) as well as the spline length and throw-out bearing sleave length to the same point.


Thanks
Dave
 
Joined
Jan 20, 2003
Messages
11,194
Location
Wherever the truck stops!!
 
 
The H55 and the H42/H41 are the same on the front end as far as dimensions bolt locations, threads etc etc. are concerned. Gearing is different and the H55F is slightly longer (about 3") but the same bellhousing can be used for both H55 and H42/H41. There are variations in the input shafts depending only on which engine it is mated to.
 
Joined
Apr 1, 2005
Messages
98
Location
Northern California
5.875" tip to bearing cover lip on H55. This is for F series or H. I think the B series are longer and I will check tomorrow. Hope that helps
 
Joined
May 19, 2005
Messages
273
Location
Northern Kentucky
 
 
 
Thanks. Bcon I'm assuming the front bearing cover lip and the bellhousing mounting surface are the same? I'm trying to mate up a 1UZ to a H55.
Dave
 

Users Who Are Viewing This Thread (Users: 0, Guests: 1)

Top Bottom