FS - 40 quarter panels

[82cruiser]

Chris Pals is selling a new set of 3/16" FJ40 quarter panels for $300. These were produced by Nick Jennings and Chris a few years ago.

If you have any questions about the panels, please ask Nick (Zebrabeef) or email Chris here:
[FONT=&quot]
[/FONT]
[FONT=&quot]chrisp34@comcast.net [/FONT]

 

[zebrabeefj40]

That would be zebrabeefj40... ya fergot the ...j40 part. ;p

The panels are laser cut and bent 3/16" steel. The filler hole fits a late '74-'78 filler door as is but can be cut for any other filler door as needed (Jeff McGarry cut his for a '72 arched fuel filler opening). The wheel arches are pre-cut for most standard aftermarket fender flares with the axle in the stock location. They replace the section of the quarter from the door post to the amby door openings and from the edge of the hardtop recess to the bottom of the body. They do not have a folded lip around the bottom; with the material thickness a lip isn't needed.

I have a picture or two of the panels I installed on a Cruiser but not on this computer. I'll try and post them up later.

Nick