front 3/8" 80 series MAF coil spacers - free to a good home

[murf]

I have a pair of 3/8" front coil spacers that I was going to use for offsetting the ARB when I got it a couple of years ago. I went with larger spacers instead and these have been collecting dust on my workbench.

Help fight stinkbug stance!

Ill bring to the meet next Friday to whoever can use them.

 

[cook]

Murf,
I'm putting Js on the cruiser with the arb in front and the Tomy bumper in back. Do you think stinkbug will be an issue with that set up? Isn't this what you were runing? Js with the ARB and Tommys bumper?

 

[murf]

Murf,
I'm putting Js on the cruiser with the arb in front and the Tomy bumper in back. Do you think stinkbug will be an issue with that set up? Isn't this what you were runing? Js with the ARB and Tommys bumper?

Not with that heavy rear bumper you wont have any stinkbug happening IMO. I did my ARB before I did my rear bumper and thats why I did the spacers.

If Pete doesnt want them, Jackson gets 'em

 

[cook]

I pass. Thanks.

 

[Tools R Us]

Murf,
I'm putting Js on the cruiser with the arb in front and the Tomy bumper in back. Do you think stinkbug will be an issue with that set up? Isn't this what you were runing? Js with the ARB and Tommys bumper?

With a full J' setup, a stock weight rig will be lifted about 3.5" front and 5" rear. It's setup this way to allow for rear cargo, ~800lb and it sits level. With your breeding stock and supporting equipment I doubt that stinkbug will be an issue!

IIRC the weight difference when installing that ARB is only ~60lb? Not much of an issue.

 

[enterconnect]

I'll take them Murph. I might need them when I install a lift. If not, they will be givin to a new home for FREE.

 

[murf]

Jackson has claimed them earlier today via PM.

 

[enterconnect]

Sounds good. Thanks Murph.