For those considering a Slee rear bumper

[sleeoffroad]

Very nice Paul...

Here's the newbie...

Need to figure out the jerry can rack position. Supposed to be one step lower, but nowhere to install the center bracket so it is where it is for now. Hate to drill into the swingout?

The basket can go in either position. On the lower wrung you have to drill and tap the swingout arm for the center support.

 

[steenh]

The basket can go in either position. On the lower wrung you have to drill and tap the swingout arm for the center support.

Thanks... I'll leave it where it is. Won't be used all that often and not concerned about rear visibility when I have the cans loaded.

It's just as impressive as the one I just unloaded. It will make the switch to my next hundy when this one dies... if it doesn't outlast me.

 

[Kigiin]

The basket can go in either position. On the lower wrung you have to drill and tap the swingout arm for the center support.

Like this...

I decided I didn't want it higher blocking my rear vision on that side.

 

[yeti in ga]

Looks nice !! How do the 863 feel now with the added weight on there. ??

 

[pfran42]

Looks nice !! How do the 863 feel now with the added weight on there. ??

Much better! I need to finish with my winch install and lower the torsion bars to get the rake trimmed out. Alignment after that and I am good to go!...Until shocks and skid plates!

 

[yeti in ga]

I am loving the Slee heavy springs.. If anyone local wants to buy a set of 865 springs let me know.