Hello all. I’m familiar with 60s-90s GM, 60s-00s Ford and now lots of 2011+ MOPAR interiors but I have ZERO experience with Toyota’s interiors. My 2008 GX’s interior trim and panels feel VERY fragile and VERY brittle. I feel like I’m going to snap these things in half trying to pry off. Is there a guide on where each clip and pry point are for the console, dash, interior panels and door panels?
I got lucky when I took out the glovebox to remove the CD changer but that is when I knew this was going to be a nightmare for the console and dash trim (for my new radio install). I also suffered broken clip tabs on two of the rear hatch door’s trim pieces...
Any help is greatly appreciated.
I got lucky when I took out the glovebox to remove the CD changer but that is when I knew this was going to be a nightmare for the console and dash trim (for my new radio install). I also suffered broken clip tabs on two of the rear hatch door’s trim pieces...
Any help is greatly appreciated.
