What do I do to fix this? Any information would be appreciated.
DMX
DMX
Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
DMX84 said:What do I do to fix this? Any information would be appreciated.
DMX
DMX84 said:Thanks Hoser & LexsusBen
Here is a not too old picture of my TB. I’ve been reluctant to clean it because on my VR4 it kills the O rings in the TB. Also, I’m not sure if you can just reach in and crank open the TB plate (on the VR4 you just open the throttle) but on the Cruiser it is motor controlled, is it ok to just manually open it? And you mean not to get the cleaner on the TB motor, correct?
I’ll probably get to this tomorrow.
Thanks again
Dean
Got her all cleaned up and reset the ECU using my code reader. I’ll report back as soon as I find anything out. But no news is good news!
Thanks!
DMX
I just cleaned my Maf sensor and throttle body yesterday. I use maf sensor cleaner spray and throttle body cleaning spray.
I removed the throttle body and unplugged the electrical 8 pin connector so I could clean it more easily. When I reinstalled it and plugged the connector back in I found that I had broken the locking tab on the connector.
I ordered this hoping it is the correct connector. I’ll post back when I receive it if I remember.
Amazon product ASIN B07HZY9KL7
Bumping old thread.
Was this part correct? The clip is broken on mine as well.
When you removed the TB did you replace the gasket or reuse the old one? I am having a low idle at start up and sometimes the car is stalling out. I am going to try to clean the Maf sensor and TB to see if it help.I just cleaned my Maf sensor and throttle body yesterday. I use maf sensor cleaner spray and throttle body cleaning spray.
I removed the throttle body and unplugged the electrical 8 pin connector so I could clean it more easily. When I reinstalled it and plugged the connector back in I found that I had broken the locking tab on the connector.
I ordered this and it was the correct part, and I was able to take apart the old connector, leaving all the pins intact, and just popped them into the new connector.
Amazon.com: GENUINE OEM NEW replacement Connector & terminals for Toyota/Lexus 90980-11858 : Automotive
Buy GENUINE OEM NEW replacement Connector & terminals for Toyota/Lexus 90980-11858: Automotive - Amazon.com ✓ FREE DELIVERY possible on eligible purchaseswww.amazon.com
View attachment 2327289
Update? I now have this issue and plan to do the same as all ya'll. Thanks.Just cleaned everything out and reused the old gasket. I'll update after a few weeks.
Truck is running great and I have not had the issue again. I took the throttle body off to clean it the best I could as well as the MAFS. All the cleaners should dry quickly but make sure its dry before putting it all back together.Update? I now have this issue and plan to do the same as all ya'll. Thanks.