Blast cabinet, need the use of one

[Malleus]

Does anyone on the Charlotte side of the state have a blast cabinet large enough to put the 80 series intake halves into? It needs to be roughly 33"x 20" and at least 12" high, inside.

I used my benchtop model for this last time, extending the door opening by the redneck expedient of a trashbag over the open door, but I'd rather not do that again.

I have clean glass bead media for you in exchange for the use of the cabinet. And I'll clean yours.

LMK

 

[Malleus]

EDIT:
It has found a new home; Rafael's body shop.

---

Obviously I'm the only one, so I broke down. Now, if you need one that's 36" (–ish) x 23" (–ish), on the work surface, LMK. It'll be up and running by next week.

Oh, and I don't need two, so I have a benchtop (–ish) model, on a cart, that needs a new home. I'll even supply the glass beads (because I'm too lazy to clean them out). It's sort of this one:

Except it's not grey, it's red. And so is the cart it's on; it's sort of this one, without the middle shelf:

I got tired of lugging the thing around every time I needed to use it, and then having to find an unused (impossible) table to out it on. I may have the middle shelf somewhere, but I can't promise that.

Everything works as it should, but the cabinet work surface is too small for the parts I need to put in it.

 

[lastresort576]

Make sure you look up the mods for the blast cabinet...and you absolutely, 100% have to do is seal the cabinet with silicone caulking as you assemble it. between every mating surface. The more caulk the better.

I actually run/created a rather large HF mod group on FB in case you're interested in searching for the blast cabinet mods there. Its: Harbor Freight Modifyers. Relatively solid group...some redundancy and bs but with only myself and one other person helping me mod the group of 275k members, it stays relatively neat n tidy.