Big A$$ Torgue Wrench - CLT

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

D

Dino

10 Year 15 Year 20 Year
Joined
Sep 3, 2004
Threads
43
Messages
237
Location
Charlotte, NC
Does anyone have a 300lb torque wrench I can bumb for a few days. I need to replace my oil pump seal, it's bleeding pretty hard right now.

Also, if anyone wants to lean a hand I can supply plenty of libations for the service.

Dean
 
Well i'm going to take a wild stab in the dark here.... since his location is listed as Charlotte, NC and his title says CLT meaning Charlotte, i'm going to say he must be in Austin Texas :p:flipoff2:



I should have one you can borrow..... i've just got to find it first :doh:
 
yeah, i didnt know clt was charlotte either...
 
but i have one if needed. digital does angles as well...
 
CLT sounds a little dirty. if it wernt an airport that is. too bad im in DCA
 
Sorry about that the CLT - I live in the airport and assume everyone in the world knows the airport codes...my bad!
 
Doesn't really matter your location under your screen name clearly says Charlotte, NC ;p


Still haven't found mine... might have loaned it out already and forgot..... i'll let you know if I trip over it.
 
Ok finally found my tq wrench ( in the suburban) but it only goes up to 250 ft/lbs...... best bet would be the rent a tool from auto zone. :cheers:
 
You could do a quick calculation with a 250 # torque wrench and get pretty close to factory spec for the crank pulley if that is what you are trying to achieve.
 
You must log in or register to reply here.

Share this page

Back
Top Bottom