Best lift for 2003 tacoma

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Best or most cost effective ;) I say go with OME, stay away from bracket lifts, Coilovers are nice but need rebuilding often and are traditionally 2x the cost of OME up front. I have some OME front coils and Bilstein shocks FS for the front. My rear setup wont work on a Taco. Click the link on my sig to see my build.
 
Cheap = spacer and rear add a leaf.

Nicer = OME full suspension lift.

Mo nicer = Adjustable coil overs.

Mo mo nicer = long travel.

We can hook you up with any of those. Give the shop a call 864-280-4238.
 
Thanks for the advice! I thought everyone had died around here! It must be busy where y'all are too:) I think new coils are probably the way to go since I'm gonna need new shocks probably since mine are so old and I think they're a little bouncy... I'll have to check out your thread 89s, Will you sell just the front?? If so how much? Have to check out the funds... Not much available right now after the truck purchase:( Thanks too Steve I'll have to call ya...
 
Thanks for the advice! I thought everyone had died around here! It must be busy where y'all are too:) I think new coils are probably the way to go since I'm gonna need new shocks probably since mine are so old and I think they're a little bouncy... I'll have to check out your thread 89s, Will you sell just the front?? If so how much? Have to check out the funds... Not much available right now after the truck purchase:( Thanks too Steve I'll have to call ya...

We are now a direct ARB dealer - so we can cure what ails your Taco.
 
I would sell just the front. $275 to a UC member. I should have it swapped out this week.
 
So the front is 883 OME and bilsteins, right? That's what I saw on your build thread... Are the shocks in good shape or need to be replaced? If I can get some money and you still have them, I may be interested!
 
The shocks should be OK. I will know for sure once I get my new ones on. I think my front end vibrations are from my KM2s. Apparently I did not rotate them enough and the front two are cupping some. When I install the new front shocks and springs if everything smooths out then I'll greatly discount the front setup.

Front shocks and springs have ~ 50K miles on them. FYI the 5100s are rebuildable through Bilstein when they do need it in the future.

I will also be selling my 255/85/16 KM2s sometime in the next few months if your interested.
 

Users who are viewing this thread

Back
Top Bottom