ARB indicator lights wiring (1 Viewer)

[Trunk Monkey]

Just got done installing the bull bar and ready to wire up the lights. As usual, ARB instructions are a little light, "wire indicators into vehicle wiring". So, what do I tap into? Out of the turn signal lamp I've got Green, Green/Yellow, and Black/Yellow. The ARB splice is blue wire and brown wire.

Thanks.

 

[Trunk Monkey]

Well, you tap the two with the stripes on each side (DS was the same except for green/gray stripe rather than yellow). The solid green is the marker, the other two are the flasher. Doesn't really matter on the ARB end of things if you use blue or brown, just as long as you're consistent through the Molex connector.

I8uIt

 

[Liam]

ok, question.

trying to wire my sheiot up, but wanna use them as blinker and marker lights. My bumper wires are black and red, not blue and brown.

I know i have to change out my light to an LED, but does anyone know which wires i connect to??


it's on a 98

 

[1loudLX]

It's going to require a little more then just tapping in since the marker will backfeed the signals if you use the current bulb setup. Just make em turn signals and leave it at that, much cleaner

 

[Liam]

It's going to require a little more then just tapping in since the marker will backfeed the signals if you use the current bulb setup. Just make em turn signals and leave it at that, much cleaner

so for just turn signals i tap one wire off the bumper into the green with a stripe and the other into the solid green? I dont use the white with the blue stripe for anything, right??

 

[1loudLX]

i think thats right, the LX has different wiring then the LC. Check with someone that has the wiring manual