ARB Front Bumper 3411050 bar diameter

[pless]

Hey guys, first thread started here!
Anybody has the dimension of the bars on the ARB 3411050 front bumper.
been searching around and can't seem to find anything.

I am asking so I can order the bumper and the right light clamps at the same time.
Thanks in advance,
PL

 

[ERG80]

ARB Bar DOM tubing diameter?

Guys, I'm having some difficulty verifying the diameter of the DOM tubing for the FJ80 ARB Bull Bars. Specifically across the top where the tabs are (though I think they're all the same). Purpose: verify for fabricating hi-lift jack mount, similar to fourtreks version. Thanks!

forum.ih8mud.com

I found this thread a while back when I was trying to match my 4x4labs tube to the arb tube.

 

[pless]

geez... i swear i tried searching on here and could not find jack...

Anyway, thanks man!!

 

[pless]

Thought I would post some more info on this if it can help anyone else.

The thread mentioned above by @ERG80 states:
Top Bar: 1 7/8" (48mm) Diameter
Midline Support bar: 1 3/8" (35mm) Diameter

Which I confirmed as correct from another source.

Otherwise, I also found out that the ARB Front Bumper 3411050 comes with welded tab for lights on the middle bar and for antennas on the top bar

Hope this helps!

 

[BILT4ME]

Thought I would post some more info on this if it can help anyone else.

The thread mentioned above by @ERG80 states:
Top Bar: 1 7/8"
Midline Support bar: 1 3/8"

Which I confirmed as correct from another source.

Otherwise, I also found out that the ARB Front Bumper 3411050 comes with welded tab for lights on the middle bar and for antennas on the top bar

Hope this helps!

What is that in mm so I can do it without converting?

 

[pless]

What is that in mm so I can do it without converting?

Good point I edited the post above to show both imperial and metric.