SOLD ABQ, NM: Hewitt Tech Gen-II SAIS Bypass Kit

[empty80]

Location

United States

Fitment: 200-series Landcruiser, 2008-2011,2013-2019, 5.7L (3UR-FE) G2-2B57H1

$250 shipped.

I purchased the kit the last week of October, and used it to diagnose a electrical issue. It was only run for approximately 70 miles between Santa Fe, NM and Albuquerque, NM. It’s in great condition with all components. Block-off plates were not installed.

 

[lostonaroad]

Fitment: 200-series Landcruiser, 2008-2011,2013-2019, 5.7L (3UR-FE) G2-2B57H1

$250 shipped.

I purchased the kit the last week of October, and used it to diagnose a electrical issue. It was only run for approximately 70 miles between Santa Fe, NM and Albuquerque, NM. It’s in great condition with all components. Block-off plates were not installed.

Long time but still around?

 

[empty80]

I’ve still got it hanging around.

 

[lostonaroad]

I’ve still got it hanging around.

$150 to take it off your shelf?

PS, loved your build thread!

I had sooo many of the same issues as you. Time, lots of reading and elbow grease fixed most of them. The lollipop piece took me down memory lane from installing my bud built sliders, I can laugh at it now but damn it sucked when I was in the middle of it.

Are some of the pictures below the thread from Telluride/Ouray? Ive spend quite a bit of time out that way and am hoping to do black bear pass/engineer this summer.

 

[lostonaroad]

I’ve still got it hanging around.

$200?