92mm hole saw

[Vanny]

Anyone have a 92mm hole saw I could borrow to make a hole in my right front fender ?

 

[Granite Grinder]

Darn, I only have a 100mm hole saw, holes in fenders sound scary... but look cool!

 

[canucksafari]

If you can't get one, you might be able to get a smaller body shop to do it for cash. The ones I have seen done have been done with a metal cutting wheel on a dremmel or a metal blade on a jig saw. Just drill a small hole to start the jig saw. If you go the jig saw route, make sure you put masking tape on the bottom of the feet so you don't scratch your paint.

 

[chet]

3.5" hole saw and then file the rest. (3.5 = 90mm)

 

[Glenn-BJ74]

If you are doing the snorkle thing I recall 3.5" fits fine.

 

[Granite Grinder]

You can borrow my Plasma cutter. It requires air, but will run on 110V. Of course, I think Greg's OP was just teasing us.
Phil

 

[Vanny]

The snorkel is stored away safely until install. I am having the cruiser painted first week of August so I want the hole cut by then.

 

[Fantom]

I do have one, but it requires the Green Lee drill adaptor to be used which I can't give out since I use it for work regularly. Is the truck drivable? can you come by my shop in New West with it?

 

[jcolvin]

Yep I have one bought for precisely that use, works fine on a regular drill I'm in Richmond 604 209 5309