whats the fine toothed(teethed or however you say it) gears on the left side of the ring gear for?
7.3 Powerstroke diesel swap?
- Thread starter helocat
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
It seems like dodge has some ultra redundent measures for their ABS. if you look at the housing theres a big arm on the top that runs forward and to a box(ABS.) too.
just take the PSD remove body and put cruiser body on and trim up the leftovers
- Thread starter
- #25
The inside thought was the quotes would be crazy low, I was going to bid $3K then heard the top bid. Freeken thing sold for over $9K. Other bids where no bid’s, other yards did not want it. Yes retail the motor is most likely $7k’ish but this was wholesale, a wreaking yard typically wants to double their $. No way is there $18K of parts on this thing, all that is there is the drive train. I know the yard that got it so I may offer a few $ for the axels before they pick it up. On the other hand I bet they are doing the math and think they need to get $5k for the axels. 
Update too, the motor actually turns out to be a 6 ltr and not the commercial 7.3.
The truck I wanted to put it into would have been a 91-92 FJ80.
Mark
Update too, the motor actually turns out to be a 6 ltr and not the commercial 7.3.
The truck I wanted to put it into would have been a 91-92 FJ80.
Mark
HZJ60 Guy
Tank Buster
Sell it and buy a Cummins. Plenty of people have done that swap before.
Besides, that struggle stroke isnt a great engine anyway. I'd be surprised if it fit in the engine bay.
TB
Besides, that struggle stroke isnt a great engine anyway. I'd be surprised if it fit in the engine bay.
TB
