- Location
- United States
HJ61 cable locking axle set. 4.11 have the pull cables but not the lever box.
Located in 100 Mile House BC, willing to put on a pallet for shipping, may be able to get them to Vancouver area.
Front end is pretty tight, may require seals/ wipers in the near future. Rear end has been rebuilt (new bearings) a couple of years ago.
Ran these axles in a bj60 for a few years but am going to 80 series diffs.
Rear full floater has been set up for disc brakes, bracket is welded on to accept front 60 series rotor and calipers. This combined with the larger 4runner calipers up front worked very well and didn't require a proportioning valve. The caliper bracket can be easily cut off if you wish to restore them to drums. I ran a Tcase e-brake with this setup and can throw that in with the deal. Diff cover/ armor welded on rear housing.
Located in 100 Mile House BC, willing to put on a pallet for shipping, may be able to get them to Vancouver area.
Front end is pretty tight, may require seals/ wipers in the near future. Rear end has been rebuilt (new bearings) a couple of years ago.
Ran these axles in a bj60 for a few years but am going to 80 series diffs.
Rear full floater has been set up for disc brakes, bracket is welded on to accept front 60 series rotor and calipers. This combined with the larger 4runner calipers up front worked very well and didn't require a proportioning valve. The caliper bracket can be easily cut off if you wish to restore them to drums. I ran a Tcase e-brake with this setup and can throw that in with the deal. Diff cover/ armor welded on rear housing.
Last edited:
