2F Engine and Other FJ60/FJ40 Parts

[recneps]

4spd and Transfer Case, 2F Carb

I need some space - some big and heavy (local sale preferred), and other smaller parts that have come from parts vehicles as well as my own.

Big and Heavy (unless you know how to get smokin' deals on freight shipping, or live in or around Atlanta, you may want to skip these):
Out of a 1987 FJ60 (about 120k miles on the ODO) that I bought and drove from Conyers to Marietta, GA a few months ago...
-Complete 2F Engine with accessories, bellhousing and clutch, minus air pump and carburetor - $350 - (SOLD)
-Set of 5 original chrome wheels and tires (tires are near the end of their life) - $85 - (SOLD)
Out of a 1980 FJ40 that was in a downtown Pull-A-Part...
-Complete 4-speed transmission AND transfer case - $250 - (SOLD)

Smaller, shippable items:
-2F Aisin carburetor, ran fine on the 2F above - $200 - (SOLD)
-2F Aisin carburetor, rebuilt by Jim Chenoweth (have receipt), then immediately replaced by a Weber (problem was in the emissions system, not carb) - $350 - (SOLD)
-2F Aisin carburetor, off of the 1980 FJ40 Pull-A-Part truck above (unknown working condition) - $40


If you have any questions, please let me know. I will be happy to snap some pictures and send to you if you are interested in any of the above.

Thanks,
Spencer

 

[mtrdud]

2F

You have PM

 

[orangefj45]

location???

 

[lynchmob]

Big and Heavy (unless you know how to get smokin' deals on freight shipping, or live in or around Atlanta, you may want to skip these):
Out of a 1987 FJ60 (about 120k miles on the ODO) that I bought and drove from Conyers to Marietta, GA a few months ago...

close?

 

[mtrdud]

Looks like ATLANTA, GA.

Looks Like Atlanta, Ga.

 

[recneps]

Actually Marietta, GA (which is about 20mi North of Downtown Atlanta). I updated my profile to show the location.

Responding to PMs now.

Thanks,
Spencer

 

[mtrdud]

2F

Does anybody know if the 80 4-speed and transfer case is a direct bolt up to the 2F out of this FJ60?

 

[hank14]

How about pics of the 3 carbs- especially the rebuilt one?

 

[BGarcia88FJ62]

I'd be interested in the rear lift gate and the skid plates can you give me an idea of their condition. I'm pretty local would it be O.K. to drop buy and eyball the whole truck .

 

[recneps]

Carb pics

Hank14,

Here are pictures of the carbs mentioned above...
http://www.brewniversity.com/images/lc/image001.jpg
http://www.brewniversity.com/images/lc/image002.jpg

Left to right:
1. Aisin pulled off a 2F in a 1980 FJ40 at Pull-A-Part (don't know if it runs, but should be a good candidate for a rebuild.
2. Aisin pulled off a 2F in a 1987 FJ60 that I drove home last summer and am partially parting out (minus the stuff I need).
3. Aisin pulled off a 2F in my 1987 FJ60, totally overhauled by Jim Chenoweth and only installed for a short period of time since the problem was misdiagnosed, so I did a Weber conversion to do away with the offending emissions gear.

Two additional pictures of #3 above:
http://www.brewniversity.com/images/lc/image003.jpg
http://www.brewniversity.com/images/lc/image004.jpg

**I like to think of myself as relatively intelligent, but I couldn't for the life of me figure out how to upload more than one tiny image (256 color, 200x300) before I was over my 'quota'. I see other threads with tons of pictures - what gives? Any advice would be appreciated.

Thanks,
Spencer

 

[recneps]

BGarcia88FJ62,

As I recall, the rear lift gate has some of the typical rust spots in the lower corners, although I would like to keep all doors and windows intact in the interest of preserving the excellent condition of the interior - at least for now.

Since I want to keep some driveline items (axles/housings and such), it may be best for me to go pull off all the things that I am selling and post that list.

Thanks,
Spencer

 

[redcorn]

Jim C carby for $300.00?

 

[recneps]

Jim C carby for $300.00?

$350 for the Jim C carb. The rebuild cost $300 alone, and I don't really want to give away the carb.

Thanks,
Spencer

 

[HENDOG]

Pmed you about motor.

 

[Wadesters]

Parts

PM Sent...

 

[mtrdud]

Parts

Spencer,

PM and email sent.

Thanks,
Clyde

 

[octongue]

still have the motor?
(yes i realize i will have to freight it here)

 

[mookie]

leaf springs

do you have any rear leaf springs off of an fj60?

 

[recneps]

Leaf Springs

do you have any rear leaf springs off of an fj60?

Only a set of extremely saggy ones that came off my '87. They are hanging out waiting for me to take them to the metal scrap yard.

Thanks,
Spencer

 

[mookie]

well, it just happens that i am looking for a soft pair to use on my rock crawler, i'd love to take those off your hands....how much?