Anyone running them? Safe? Got a set I can borrow? I might do something drastic in the spring but just wanting to see if the width will improve things.
2" wheel spacers on your landcruiser (1 Viewer)
- Thread starter WrenchMonkey
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
Been running them on Gavin's HJ60 for 4 years no issues. Just put a HDJ81 full floater in the rear so have two spacers you can borrow. I think they are 2" but I have not measured them.
But I had had spacers on a few trucks with no negative side effects so I would not be worried about it. Just need to make sure you re torque them after 200 or so KMS.
Make sure you follow the manufacturers' installation instructions.
For my 1.5" Spidertrax spacers they require red lock tight to the wheel studs and 85 ft-lbs of cross-crossed torque.
Torquing them too tight can pull the steel studs through the aluminum.
For my 1.5" Spidertrax spacers they require red lock tight to the wheel studs and 85 ft-lbs of cross-crossed torque.
Torquing them too tight can pull the steel studs through the aluminum.
