1995 80 series rollover

[JAPFPE]

Since my 1997 LX450 has been totaled by the insurance company, my 1995 parts truck will likely need to go. I will know this week if I plan to buy the truck back from the insurance company but it is very unlikely at this time. The parts truck is a 1995 80 series WITH LOCKERS. I bought it off this board approximately 16 months ago from a fellow cruiser head with the intent of flipping the axles to my LX. The LC was well maintained by the PO. My LX was hit in front of our house last week by an intoxicated driver. I'll likely be moving on to a 100 series.

The truck in question is a maroon 1995 80 series that was rolled on the drivers side and on to the front DS corner of the windshield. The truck is intact except for the cat's which I removed. The DS doors, rear quarter, windshield and front fender are trashed. The truck has approx 185k miles. Truck is stock except for the 285 Revo's.

I will not part the truck out but would rather sell as-is. It is in running condition to load onto your trailer. Located just east of Syracuse, NY. I need to sell this by the end of next week.

Pleaase PM me if you are interested and can pick-up by the end of next week.

Thanks!

 

[landtank]

PM sent!

 

[4Cruiser]

Do you have the front axle & trailing arms/radius arms?

 

[JAPFPE]

All PM's have been answered. The 1995 truck suspension and driveline is intact. I will not part it out since I do not have the time or facilities to do so.

 

[maxafterburn]

PM sent

 

[JAPFPE]

All PM's answered.

 

[JAPFPE]

Pictures

Here you go folks! I threw my fiberglass bed cover for the Taco on top of the LC for ease of storage....this truck has been garaged since I bought it.

 

[samuel]

hi,

if you part this out, i'm interested in the interior (color = tan?)

looking for good front seats and door panels

thanks,
sam

 

[NorCalDoug]

if you're going to...or if whomever buys this is planning to part it out, I'm looking for the "Y" pipe that runs from the manifold to the cats.