15x8 version of oem 42601-60262-03 ?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Feb 9, 2020
Threads
6
Messages
83
Location
CA & OR
I suck at searching for parts. Is there a 15X8 version of this oem wheel?
The 16" below is PN: 42601-60262-03.
I have roh 15x8 -22 wheels, one with a crack, and the shops around here only repair aluminum.
I figure an old school oem wheel would look ok on the tire carrier.
Thanks!
wheel 42601-60262-03.JPG
 
I suck at searching for parts. Is there a 15X8 version of this oem wheel?
The 16" below is PN: 42601-60262-03.
I have roh 15x8 -22 wheels, one with a crack, and the shops around here only repair aluminum.
I figure an old school oem wheel would look ok on the tire carrier.
Thanks!View attachment 2502388
Hi
Did you ever find the correct part number for the 15x8 wheels?
I am also looking to replace some aluminum ones....
Thanks
 
Hi
Did you ever find the correct part number for the 15x8 wheels?
I am also looking to replace some aluminum ones....
Thanks
No, and after a second wheel developed a leak in the same spot, I gave up and painted 5 new white wagon wheels.

IMG_9906.jpg
 
No, and after a second wheel developed a leak in the same spot, I gave up and painted 5 new white wagon wheels.

View attachment 3094513
They ended up very nice, and fit the era.
Can you share the nominal size and width and offset (or backspace)?
Did you need to use spacers to clear the brakes, steering joints or rear well?
Thanks
 
They ended up very nice, and fit the era.
Can you share the nominal size and width and offset (or backspace)?
Did you need to use spacers to clear the brakes, steering joints or rear well?
Thanks
fRD7NRLbUmzYDzo_YSKUlnZg34iAMvE8cVhSRgqlWLEvT5o72Ev3dkDTYESA_3FQQuGk5sue-kjjAbz8Amga7z3yguneyHvZINlkemh-o41V7XRSSHrDWA=s0-d-e1-ft
USW-70-5860
Wheel, 8-Spoke, Steel, White, 15 in. x 8 in., 6 x 5.5 in. Bolt Circle, 3.75 in. Backspace, Each
(Mfr. #: 70-5860)

and had to use spacers to match the offset on the old wheels,
 
So I see there is no running away from reducing the backspacing of the wheel to 3.5", at least for the 15" wheels
What would you consider the biggest clearance issue? the steering ball-joints or the rear inner fender well or the brake components?
I would have gone to 16's if I could (regulations prohibit these changes here) and thought that at least on the 16's (hopefully 6 or 7 inch wide) I cold go with a wheel that is zero or even positive offset without the need of spacers (or at least only the 6mm ones).
Your experience with these wheels can contribute a lot to the decision making process.
Thanks
 
I think it was the steering ball joints, but there could be more. I'm not knowledgeable enough to answer that.
After giving up, I wanted to get the same roh wheels but shipping wasn't worth it. And if I had to choose again, I'd try to get the roh wheel and not have the spacer.
If I ever wear out my current tires, I'll ask you if you ever found the Toyota wheel!
Cheers
 

Users who are viewing this thread

Back
Top Bottom