- Location
- United States
Not sure what was going on, but this system was not working, but probably a wiring issue...It would not stay in the run position but would immediately move to the stop position.
It worked properly for years, then I did some rewiring, it would not behave, and I just bypassed it and removed it.
I have two EDIC relays (one appears toasted), the other was a $100 SOR purchase that did not fix the problem. I also have most of the EDIC arm, but kept the end fitting. See: IH8MUD Forums - View Single Post - Sheila's evisceration and birth of an HJ62 -> Tofudebeest
This is off of an 10/80 Aussie-spec HJ60 2H motor. It is clean and presentable.
$75 for the lot, OBO. You pay shipping.
If it turns out to be defective, I'll provide a refund.
It worked properly for years, then I did some rewiring, it would not behave, and I just bypassed it and removed it.
I have two EDIC relays (one appears toasted), the other was a $100 SOR purchase that did not fix the problem. I also have most of the EDIC arm, but kept the end fitting. See: IH8MUD Forums - View Single Post - Sheila's evisceration and birth of an HJ62 -> Tofudebeest
This is off of an 10/80 Aussie-spec HJ60 2H motor. It is clean and presentable.
$75 for the lot, OBO. You pay shipping.
If it turns out to be defective, I'll provide a refund.
