tach

Hi everyone, I’ve got a weird electrical issue with my 105 1hz cruiser which is stopping it from shifting gears. When cranking it shows 500rpm but when it starts running it goes all the way up to 4500rpm at idle while it’s actually sitting at 600rpm. As tempature increases it increases rpm on...

So, I'm not sure anyone have done it before, and since I couldn't find any info neither here nor on the web – here we go. For two simple reasons of: – the sensor, being just a coil in epoxy, is notoriously expensive (250-350$ last I checked in 2025) – I don't like aftermarket gauges that don't...

Good evening, I am working in a 1995 fzj75 and have replaced the cluster. The updated cluster has a tachometer. The engine in the vehicle is a 1FZ - FE. I have not been able to find a good tach signal to get tach working. Any help would be appreciated

I have a 1995 75 series and replaced the cluster. The old one did not have a tach in it and I wanting g get it working. The info I have says it is a black wire terminal 11 connector I am wanting make sure that is accurate because new cluster came with connectors and none of the colors are...

Ok i tried to search this up found a few articles but I have the following problem. My tach went out came here read a little and replaced the igniter, that did not work so I buy a complete dash unit replace the igniter because it was bad, put the new to me dash in, and it worked for about a...