suspension

New warn hubs part # 28771. $200 plus shipping

I have a dobinson kit for my HDJ81. I am wondering if I will need extended brake lines or anything else. If I do can someone send me a link? I also do need to replace my brakes and maybe my rotors. If someone could link stock HDJ81 front and rear brake pads + rotors that would be greatly...

No leaks or issues. Just removed this week. $400 firm local pickup, cash. I drove the car and there were no whines, leaks, bubbles or other problems. Shipping, due to weight is about $70, I will shop for best price but shipping has become outrageous lately. No shipping outside 48 states...

98-99 front lower and upper bare, used control arms, new bushings, spacers, and stoppers(all OEM) New upper and lower front 555 ball joints. $1,200. Includes shipping.

Excited to offer 20% off for all our products on the site! Use code: BLACKFRIDAY23 at checkout to redeem your discount. Built with compression damping, a no questions asked warranty, and a progressive spring rate - check out the most advanced bolt-on bump stops on the market at: www.perryparts.com

Howdy Cruiser heads! I am wondering if these shocks will fit. They seemed to be the correct shock, although not OEM. Another forum suggested this was a comparable shock to OEM and they were a good enough price to consider going with the KYB. However, not if these don't fit. Measuring the frame...

I am selling the following as a packaged deal at $1050 plus shipping. Pics a few posts down…description below should be good reference. -Dobinson Flexi coils (C59-614V 4" Front) - 500 miles on them -Dobinson Flexi coils (C59-615V 4" Rear) - 500 miles on them -New Dobinson 5 degree correction...

I've 'inherited' some OEM LandCruiser suspension parts. I'm told they had 28K on them when they were swapped for an upgrade. I don't have a lot of info aside from the part numbers on the shock absorbers. 48510-60170 48530-60270 The 200 Series that I've listed is my best guess based on looking...

I'm in a sticky situation. Suspension or other stuff ( recovery gear, CC & MTS, recovery points, tire inflator, etc). Now, in my mind, I can always use other people's recovery gear, but I can't use other people's suspension 😇. But if I'm out alone, I might need that gear. I really want to do my...

Thanks

I am having a shop help me with a reverse-reverse-shackle ad then we'll install a new suspension. The consensus seems to be OME 2" light full kit (I don't take the truck offroad) or a 2" Dobinsons full kit or swapping out for BILSTEIN 5125 0-2″ shocks. I am trying to keep it as close to true...

Any professional welders out there (New York Tri-State area) who could help me reverse a shackle reversal on my 78. Will do a new suspension at the same time. Thanks vm.

Hello all. I am planning on an entire suspension component replacement of all rubber parts of my 100. I only want genuine Toyota parts, however I am willing to forfeit a 1 year warranty of said parts if sourced through other than Toyota in an effort to save some coin. I have a lot planned for...

So I've had my LX470 for about 8 years now, and the AHC has worked great up until now, with little maintenance. However, in the last year it has decided it doesn't want to go into high mode anymore, and even going from low to normal is a gamble. Finally, a few days ago, the AHC OFF light came...

I've been trying to figure out the source of a clack/clunk/rattle that is getting worse and occurs when I drive over rough road at low speeds. I've scoured Mud for leads and gotten some good feedback on one of my prior posts on this issue. I took it to a new garage to get a fresh perspective...

Trying to replace the crappy aftermarket driver seat that it came with in my 73. Read through a bunch of threads in seats but the one lingering question I have is about the slider rails. Currently, there is an aftermarket recaro base with welded on rails attached to my suspension base. If I look...

New Yukon grizzly locker for 9.5” axles $650

For sale is long list of parts that I have removed from the GX and others that I purchased but didn't end up needing. I will have other threads for other parts (wheels/tires, etc.) in the appropriate sections. 2 Sets of new CV boots (stock) - $50 for both cv axles (were removed from new axles...

Hello everyone, as there seems to be, quite few suspension experts...posting my question here. I own 97 LC80, with "unknown" lift from PO. By the measurements and eye, it seems to be approx 2-2.5", since rear springs started to sag after adding drawers, bumpers, wheel carrier and spare, we...

I have a pair of OME 2721 springs still in the box that I’d like to get rid of. Went with different springs for the rear. Box is a bit beat up, but I never opened it up. $125 or best offer in Phoenix face to face. Will ship but please pm to discuss shipping cost.