suspension

Excited to offer 20% off for all our products on the site! Use code: BLACKFRIDAY23 at checkout to redeem your discount. Built with compression damping, a no questions asked warranty, and a progressive spring rate - check out the most advanced bolt-on bump stops on the market at: www.perryparts.com

Howdy Cruiser heads! I am wondering if these shocks will fit. They seemed to be the correct shock, although not OEM. Another forum suggested this was a comparable shock to OEM and they were a good enough price to consider going with the KYB. However, not if these don't fit. Measuring the frame...

I am selling the following as a packaged deal at $1050 plus shipping. I will include pics when I get a chance, but description below should be good reference. -Dobinson Flexi coils (C59-614V 4" Front) - 500 miles on them -Dobinson Flexi coils (C59-615V 4" Rear) - 500 miles on them -New...

I've 'inherited' some OEM LandCruiser suspension parts. I'm told they had 28K on them when they were swapped for an upgrade. I don't have a lot of info aside from the part numbers on the shock absorbers. 48510-60170 48530-60270 The 200 Series that I've listed is my best guess based on looking...

I'm in a sticky situation. Suspension or other stuff ( recovery gear, CC & MTS, recovery points, tire inflator, etc). Now, in my mind, I can always use other people's recovery gear, but I can't use other people's suspension 😇. But if I'm out alone, I might need that gear. I really want to do my...

Thanks

I am having a shop help me with a reverse-reverse-shackle ad then we'll install a new suspension. The consensus seems to be OME 2" light full kit (I don't take the truck offroad) or a 2" Dobinsons full kit or swapping out for BILSTEIN 5125 0-2″ shocks. I am trying to keep it as close to true...

Any professional welders out there (New York Tri-State area) who could help me reverse a shackle reversal on my 78. Will do a new suspension at the same time. Thanks vm.

Hello all. I am planning on an entire suspension component replacement of all rubber parts of my 100. I only want genuine Toyota parts, however I am willing to forfeit a 1 year warranty of said parts if sourced through other than Toyota in an effort to save some coin. I have a lot planned for...

So I've had my LX470 for about 8 years now, and the AHC has worked great up until now, with little maintenance. However, in the last year it has decided it doesn't want to go into high mode anymore, and even going from low to normal is a gamble. Finally, a few days ago, the AHC OFF light came...

I've been trying to figure out the source of a clack/clunk/rattle that is getting worse and occurs when I drive over rough road at low speeds. I've scoured Mud for leads and gotten some good feedback on one of my prior posts on this issue. I took it to a new garage to get a fresh perspective...

Trying to replace the crappy aftermarket driver seat that it came with in my 73. Read through a bunch of threads in seats but the one lingering question I have is about the slider rails. Currently, there is an aftermarket recaro base with welded on rails attached to my suspension base. If I look...

New Yukon grizzly locker for 9.5” axles $650

For sale is long list of parts that I have removed from the GX and others that I purchased but didn't end up needing. I will have other threads for other parts (wheels/tires, etc.) in the appropriate sections. Rear Axle - Stock rear axle - Housing only - free rear axle shafts - free Rear upper...

Hello everyone, as there seems to be, quite few suspension experts...posting my question here. I own 97 LC80, with "unknown" lift from PO. By the measurements and eye, it seems to be approx 2-2.5", since rear springs started to sag after adding drawers, bumpers, wheel carrier and spare, we...

I have a pair of OME 2721 springs still in the box that I’d like to get rid of. Went with different springs for the rear. Box is a bit beat up, but I never opened it up. $125 or best offer in Phoenix face to face. Will ship but please pm to discuss shipping cost.

The bilsteins that came in my 95 were crappy. The Ironman i put on it is just as crappy. This thing is just punishing to drive off road. The landcruiser guys are going about twice as fast as I am because I’m getting the s*** beat out of me. It’s kind of getting old but I’m too cheap to buy yet...

I'm looking to get skid plates. Slee and Victory are my topic choices at the moment, but I'm concerned with the fact they required you to use their own diff drops. My issue is that I already have a diff drop with my lift kit (Ironman stage 2). Ironman said their drop is an inch, while both...

I have a 1991 fj80 that i am looking to lift. I am considering the OME 3“Heavy lift, as I will be putting on 35s and bumpers. My question is do I need to get the additional parts such as panhard rod, upper/lower trailing arms, and front tracking bar? How critical (or not) are those additional...

I'm chasing a rattle/rumble in my truck, but am I chasing my tail? I have a virtually all new suspension. EMU with U-bolt flip kit. New Orion TC, balanced original drive lines with new bearings. Knuckles rebuilt. Rebuilt diffs (ARB lockers and new ring and pinion gears), rebuilt brakes and...