shaft

Hey guys working on a split case, what size is he output shaft nut? Gotta pick up a socket asap

Correct me if I'm wrong.... With an open differential to determine the gear ratio: Raise both wheels off the ground, mark a tire, mark the driveshaft, rotate the tire one full revolution and count how many rotations the shaft makes. The number of shaft rotations = the ratio. Thanks Jim

Hey guys I’ve got a problem. I used a water based cleaning solvent someone gave me along with parts clean I purchase, to use after solvents' heavy cleaning. Well some of my matchmarks (axle and cage) washed off while cleaning parts. The parts just cleaned in petroleum based solvent still have...

Looking for an Oem pto winch to fit an 84 bj42lv, will piece together if partial units are out there but will require the correct size driveshaft . Will require shipping to southern Ontario. Thanks

I am looking for a frame plate set, preferably the 4x4labs one. Also looking for the steering shaft, u-joints and pass through/bulkhead joint. I'd also take a pitman arm that can be or is already reamed for 1-ton TRE. Please PM me if you have anything.

Steering shaft spacer for Land Cruisers (and pickups/4-Runners?) $20 $15 shipped. I don't recall exactly where this came from. The spacer is 1" thick and the diameter of the stud/hole pattern is 2-1/2". SOLD

I was out greasing the front prop shaft last month and noticed that when I pumped grease into the slip joint zerk that I saw the shaft extended outward and no grease coming of the seal. Dropped the shaft this weekend and upon disassembly confirmed that old dried grease will block the passage...

I have an h42 out of a bj 40 with the 21 spine input shaft, I'm wondering if I can change it to work with my ls clutch kit with 10 spine clutch disk, my cruiser originally came with a 3 speed and I was wondering if I could use the input shaft out of that in place of the the one in my h42

Anyone have a Mr. T front crankshaft seal fail in less than two years? I've been running full synthetic the entire time...not sure if that matters...and it just started to leak in the last month. We did hit a cold spell around the same time. Last weekend I cleaned everything up an let it idle...

Hey all, I have a blown transmission output shaft seal. I am pushing ATF into my transfer case and need to replace the seal. Should be a $20-$30 part but I can only find complete rebuild kits. Any leads or tips would be greatly appreciated. Thanks in advance.

Hi all, I am going to replace the seal in the extension housing of my transfer case. I am led to believe that it is just a case of removing tail shaft, flange and unstake the nut to access the seal. Is this correct? ive had conflicting advice, some say you must split the case in order to reach...

Hi guys , I need some help ! I am trying to install a PTO winch on my HZJ 78 , but have some difficulties with the drive shaft . in detail on the center leg I have 2 blocks that fix the shaft to the chassis that must be replaced ,Part 37212, because worn out badly . But I am unable to tear apart...

All, I'm looking for a 69-9/72 FJ40 Steering Shaft (P/N 45201-60022). Thanks

How long are the stock FJ40 drive/propeller shafts(5/1977)? I removed a shackle reversal from my 5/1977 FJ40 and installed an OME suspension kit. It appears the drive shaft is now too long. I'm guessing I will need to find a stock drive shaft. Jeff